| This thesis focuses on the design of radio-frequency (RF) mixers, including a broad- band downconverter mixer, an upconverter mixer and a downconverter mixer with high linearity. The basic mixer topology used in this thesis was the Gilbert cell mixer, which is the most popular mixer topology in modern communication systems. In order to accommodate different applications, the broadband mixer and the upconverter mixer were designed to be reconfigurable.;Second, an upconverter mixer with sideband selection was demonstrated in CMOS 0.13-mum technology. The transmitted sideband could be chosen to be the upper sideband or the lower sideband. The mixer worked at 5 GHz with a 100 MHz IF. The measured voltage conversion gains were 11.2 dB at 4.9 GHz and 12.4 dB at 5.1 GHz. The best sideband rejection was around 30 dB.;Third, a modified derivative superposition (DS) technique was used to linearize a Gilbert cell mixer. Simulation results predicted an IIP3 improvement of 12.5 dB at 1 GHz. After linearization, the noise figure of the mixer increased by only 0.7 dB and the conversion gain decreased by 0.3 dB. The power consumption of the mixer increased by 0.96 mW.;First, a broadband downconverter mixer with variable conversion gain was de- signed using 0.13-mum CMOS technology. The mixer worked from 2 to 10 GHz. By changing the effective transistor size of the transconductor and the load, the mixer was able to work in three different modes with different conversion gain and power consumption. |
