Analog front-end design using the GM/ID method for a pulse-based plasma impedance probe system

The Plasma Impedance Probe (PIP) is an electronic instrument that measures the impedance of a dipole antenna immersed in a plasma environment. Measurements made by the PIP provide valuable information regarding the plasma environment. Knowledge of ionospheric plasma density and density disturbances is required to understand radio frequency communication with satellites. The impedance curve provides us with significant plasma characteristics such as the electron-neutral collision frequency and plasma electron density.The work proposed here is a transistor-level implementation of the analog front-end, the non-inverting amplifier that is used to drive the antenna. The antenna immersed in plasma is excited with a sinusoidal/pulse stimulus and the output from the non-inverting configuration is fed into the difference amplifier. In the difference amplifier the output signal from the non- inverting amplifier is subtracted from the original stimulus and then fed into a high-speed pipeline data converter. The entire analog and mixed signal components are integrated on a single chip. The obvious advantages with this design are that it eliminates several sources of analog signal processing errors, thereby improving stability. A Fast Fourier Transform (FFT) is then applied on the sampled input stimulus as well as the processed signal. The input voltage FFT is then divided by the current FFT to obtain the antenna impedance. The FFT method helps in reducing transient errors and improves noise immunity of the system. The antenna impedance span curves over the frequency range from 100 kHz to 20MHz.The approach for the tranistor-level design is implementing short-channel design techniques using the gm/ID method. This is the primary focus of the thesis where the emphasis has been on using a simple and intuitive method to design the front-end amplifier in the TSMC .35mum technology. The design specifications for this amplifier are derived from the system-level simulations. The transition from a Printed Circuit Board (PCB)-based design to System on Chip (SOC) implementation is explored. This makes the design components highly specific to the application.The following are the design approaches used for the analog front-end design. (1) A detailed study of the various factors affecting the PIP instrument measurement capabilities from the previous works. (2) System-level simulation of the entire PIP system to completely characterize the analog front-end. (3) Exploration of the possible design topologies for the transistor-level implementation. (4) A novel method of analog amplifier design using the gm/ID methodology.Miniaturization of the instrument and using a pulse-based measurement scheme also offer an immediate benefit to sounding rocket missions. The reduction of power, mass, and volume will enable the instrument to be flown on many more sounding rockets than at present. The faster measurement is especially valuable since the ionospheric plasma changes in character most rapidly with altitude.