Construction Vehicles Driving And Operating Training Simulator Control And Detection Systems

To pick with the rapid development and information technology in military area of widespread use of sophisticated weapons are used in battle, the modern weapons capabilities. The unprecedented increase in supporting the army, strengthen construction on a mechanized engineering truck the security group training, in our new period of military changes in the new stage of great significance. New development of our development model某tracked a long-handled multipurpose engineering truck is our new technical equipment and the cost of the high technology. Large weapons engineering truck driving and operation of training is an important part of the engineering truck training and training needs to be consumed a lot of motorized hours, oils and equipment and needed special protection for the training cost high, the organization is difficult, has become conditioned to the equipment and maintain the most important factor. For this reason, the paper against the characteristics of the other training simulators, the engineering truck driving and to work training simulators control and detection system for research.某tracked to type a long-handled multipurpose engineering truck driving and job training, in hardware, system software and systems for the training system anti-interference the emulator of control and detection system for the design on this basis, the overall system hardware, a schematic diagram of the printed circuit board. Increased homework handle the controls in the emulator A/D into the path is not enough. This spells, the use of the extension of the chips 4053B not only solve A/D the path with the problem, and still reserved expand the space of an emulator laid the foundation of further improvement. To handle control work is complicated and with little accuracy and quality, to enhance their simulations, and of the chip A3966SLB analyzed by software programming using two hso produced two pwm waveforms to control both the servo motor. Then to handle the work process for the compiled control software, the algorithms for the simulator to the installation, commissioning wire and, truly achieving to handle the work of control, to achieve our desired goals.