Capacitive position-sensing interface for micromachined inertial sensors

In this work, issues related to monolithic integration of micromachined inertial sensors, including accelerometers and gyroscopes, are investigated.; Mechanical sensitivity, noise, and experimental performance verification of the open-loop accelerometer are discussed. The resolution of a position-sensing accelerometer can be improved by increasing the mechanical sensitivity and the accuracy of position measurement. 1μG/$Hz$ (1G = 9.8m/s2) acceleration sensitivity and 0.1pm/$Hz$ (1pm = 10−12m) displacement resolution can be achieved using capacitive position-sensing techniques.; Issues in designing a ΣΔ closed-loop sensor, such as system modelling, noise interaction, and verification of an analytical ΣΔ loop model with simulation and measurement results, are also described. A 2nd-order electromechanical ΣΔ force-feedback loop is transformed into a discrete-time ΣΔ modulator. The 1-bit quantizer is linearized using the least mean square (LMS) method that takes its nonlinear behavior into account. In the linearized model, the effective quantizer gain is determined statistically based upon the RMS value of the signal at its input. Reducing loop gain of a ΣΔ closed-loop sensor increases the output quantization noise. Interaction between electronic noise and quantization noise in the 2nd-order ΣΔ closed-loop sensor is revealed.; Vibratory rate gyroscopes for all three-axis have been implemented using capacitive position-sensing and ΣΔ force-feedback techniques.; The specific contributions of this work include: (1) The accuracy of an open-loop acceleration sensor is improved by increasing both the mechanical sensitivity and the accuracy of position measurement. The accuracy of position measurement is improved by optimizing the electromechanical interface, where the major concerns are damping and wiring parasitics. (2) By understanding noise interaction and its effect on ΣΔ loop operation, noise floor of the ΣΔ closed-loop sensor is improved. Results from the analytical model and simulation are in good agreement with measurement results. (3) The position-sensing interface can be adapted easily to demonstrate new MEMS concepts that rely on position measurement, making it a modular approach. For instance, a novel vertically-driven X/Y-axis gyroscope has been implemented using a position-sensing interface that has been designed for a Z-axis gyroscope. (Abstract shortened by UMI.)...