Based On Matlab,specialized Processing Equipment Optimization Design And Simulation Of Machining

Rising steadily as the economy, always only in a few high-grade stone, used in the clubhouse and the hotel is now widely used in various public buildings. In addition to the ground and floor outside the cylinder adopts the paving stone, as the major channel of stair also often adopts the stone material ground, but the stair handrail with decorative stone is not common, only in a handful of high-end clubs and hotels, etc. Mainly used in construction. The main reason is that the current process is more complex, lead to the production efficiency is low. Main reason is that the current process is more complex, causes the production efficiency is low. In view of this, this topic the main researching direction is:optimizing design special machining equipment to realize an efficient processing.First, the current process, the analysis can be improved. In order to improve processing technology, we can integrate, every stone machining if single process equipment, large amount of labor, the production efficiency is low, difficult to meet the quality requirements; After through the Pro/E software, the establishment of armrest stereoscopic3d model of special processing equipment.Secondly, based on finite element theory, the established3d model of each main part analyses mechanical properties (such as column, etc.), according to the analysis results can be optimized goal. After using the analysis software, for each key parts were optimized. The ultimate goal is to enhance its performance at the same time, also reduce the amount of consumables. Again, through the3d coordinate machine was carried out on the armrest of surveying and mapping, access to specific data processing section. With this synchronization, based on the principle of curve fitting, polynomial with software on the target, piecewise polynomial and cubic spline interpolation. By fitting the results, and ultimately determine the machining surface of mathematical expressions of handrail, the armrest of digital machine tool of mass production and rapid prototyping tool has a very important industrial significance.Finally, by dynamometer, detection in the case of cutting is not the same as the amount of the distribution of the cutting force, from the above data, the relation between the cutting and the cutting force diagram. By the software to regression analysis, the cutting force mathematics model is set up. Comprehensive excluding eventually determine the optimized processing technology data index.Through this topic research, establish the3d model, processing equipment and process parameters optimization, the processing technology of the armrest to get further improvement, as an efficient processing, provided a guarantee.