Design Of A General Monitoring And Control System And Its Case Customization

Monitoring and control information processing platform, is essential for the long-range telemetry remote system, we referred to it for monitoring and control system. As the developing process depending on the project needs different, in the actual development process, monitoring and control systems are often due to a change in demand,and you need new consideration and design a new system that can achieve the task.This means the process needs longger development cycle, more development funds and lowwer reliability.Developed a common monitoring system, it contains most of the monitoring and control system functions in hardware and software, so that the new demand, the vast majority of functional requirements still meet the needs of the general measurement and control system, you only need some minor changes and improve the general monitoring and control system, so that makes really a development cycle, greatly reducing the addition, due to the universal monitoring and control system itself has been certified in the actual test, which itself has high reliability, so by to develop the new system, is bound to make the new system also has a high reliability. General-purpose measurement and control system, first in the structure to meet the needs of most measurement and control system functions, and contains most of the monitoring and control system needs to use interface. Software implementation of the general-purpose measurement and control system is modular, and some parameters of the macro definition. Different interfaces for data reception and data processing have made the module, so will want to use the module in the software development process, direct introduction of the new system, to achieve the functionality in the software. Macro definition, the transfer rate, data size, data synchronization byte parameters outside of the module configuration, so that the new systems development process, as long as the part of the macro definitions to make the necessary changes, you can make the software to meet the communication agreements.Specifically addressed how to achieve the universal measurement and control system with two case studies to prove the use of common measurement and control system after the new system research and development process. And by comparison of cases to illustrate the universal measurement and control system has a fundamental change in software code reuse and software reliability.The difficulty of monitoring and control system design for general-purpose, how the software modules to be divided and how the parameters of the macro definition. On one hand, the module itself is too large, will reduce the versatility of the module, will not be able to realize the versatility of general-purpose measurement and control system. However, if the module is divided into too small, bound to the relationship between the module is too complex and not conducive to shorten the development cycle and improve software reliability. Therefore, appropriate choice of the size of the modules for the system’s versatility is essential.Therefore, a good general-purpose measurement and control system can enhance code reuse rate in the system development process and shorten the development cycle, can also greatly increase the reliability and maintainability of the software. These advantages is the system development process, research and development of special concern.