Transient jet interaction force and moment reconstruction in dynamic wind-tunnel testing

Missile divert jets are located near the missile center of mass and thrusting along a lateral axis of a missile. The firing of a divert jet perturbs the pressure distribution and thus alters the aerodynamic force acting on the missile. This is the jet interaction effect.; Testing techniques for determining the transient jet interaction effect must be able to interpret force and moment data in the presence of the modal response of the missile model. Two techniques for accomplishing this have been investigated. One technique is the Sum of Weighted Accelerations Technique (SWAT). The second technique uses the frequency response function (FRF) of the model.; In the SWAT the rigid body response of the model is determined by a weighted sum of the accelerations measured at distributed locations on the model. The derivation of the SWAT is described along with several techniques for determining the weights. The SWAT was developed by SNL for an unconstrained body. In wind-tunnel testing the model is constrained by the force balance. We extend the SWAT to accommodate the constraint. We also extend the SWAT for the reconstruction of moments. We also show that the SWAT is valid for systems exhibiting large rigid body translations and rotations. We demonstrate the SWAT by applying it to simple one and two degree-of-freedom computational models, a simple finite element model, measured laboratory data, and a large translation and rotation finite element model.; The FRF technique reconstructs applied force using an inversion of the frequency response function. A well known weakness of the FRF technique is its sensitivity to singularity. We present a derivation of the technique and address the singularity issue. The FRF technique is also shown to be capable of resolving distributed forces. We apply the technique to simple one and two degree-of-freedom computational models, a simple finite element model, and to measured laboratory data.; The SWAT is the more promising of the techniques as it does not require an accurate modal model of the test article. It also presents fewer computational problems. Both techniques may be necessary in practice to provide corroboration of the results.