A finite element model updating technique for adjustment of parameters near boundaries

Even though there have been many advances in research related to methods of updating finite element models based on measured normal mode vibration characteristics, there is yet to be a widely accepted method that works reliably with a wide range of problems. This dissertation focuses on the specific class of problems having to do with changes in stiffness near the clamped boundary of plate structures. This class of problems is especially important as it relates to the performance of turbine engine blades, where a change in stiffness at the base of the blade can be indicative of structural damage.; The method that is presented herein is a new technique for resolving the differences between the physical structure and the finite element model. It is a semi-iterative technique that incorporates a "physical expansion" of the measured eigenvectors along with appropriate scaling of these expanded eigenvectors into an iterative loop that uses the Engel's model modification method to then calculate adjusted stiffness parameters for the finite element model.; Three example problems are presented that use eigenvalues and mass normalized eigenvectors that have been calculated from experimentally obtained accelerometer readings. The test articles that were used were all thin plates with one edge fully clamped. They each had a cantilevered length of 8.5 inches and a width of 4 inches. The three plates differed from one another in thickness from 0.100 inches to 0.188 inches. These dimensions were selected in order to approximate a gas turbine engine blade.; The semi-iterative modification technique is shown to do an excellent job of calculating the necessary adjustments to the finite element model so that the analytically determined eigenvalues and eigenvectors for the adjusted model match the corresponding values from the experimental data with good agreement. Furthermore, the semi-iterative method is quite robust. For the examples presented here, the method consistently converged to a stable solution and did not exhibit sensitivity to minor errors in the measured mode shapes.