Design of an attitude control system for spin-axis control of a 3U CubeSat

This paper describes the design process of developing a spin-axis control system for a 3U CubeSat, a relatively small satellite. Design requires the CubeSat to de-spin after deployment and direct its antenna to track Earth nadir position. The one degree of freedom controller is developed for the TechEdSat, which is a CubeSat with a payload that allows for the assumption that rotation pitch and yaw rates are sufficiently close to zero. Satellite torqueing disturbances are modeled with reaction wheel noise for a more complete system analysis. Sensor noise is unmodeled. Frequency domain and time domain analyses are presented; the entire system bandwidth operates at 0.08 hertz with 43.2 decibels of gain and 67.7° of phase margin. During nominal operations, pointing accuracy with perfect state knowledge assumption maintains position with steady state error of 13.7 arc seconds and oscillates by 16.7 arc seconds at a rate of 0.7 mHertz. Artificial wheel noise is injected into the model causing the pointing accuracy to drop to +/- 15 arc seconds. Environmental disturbances are modeled extensively; the magnetic field torque is the worst disturbance, at 4.2e-7 Newton-meters. A 0.2 Amp˙m2 magnetorquer dumps the excess momentum every 7.75 hours and require 1.5 hours to complete. In the deployment simulation, a 1 rotation per minute spin is arrested with no angular offset in 60 seconds. Future plans include utilizing the model to build and fly a prototype reaction wheel on a future TechEdSat mission to verify modeled expectations.