Models for mass transfer effects in semi-fuel cells and for a silver-zinc battery

Semi-Fuel Cells (SFCs) and Silver-Zinc batteries have been recognized as batteries for high power applications. For channel flow between two parallel plates, featured in SFCs, obstacles may take the form of ordered asymmetrical porous nets. The net controls the spacing between the two electrode plates. The effect of the inert insulating net and its geometry on the heat and mass transfer characteristics in such a system is presented. The governing equations for momentum, continuity, and energy are solved in a three-dimensional domain using a commercial computational fluid dynamics software for fully developed flow with constant temperature boundary conditions. The local Nusselt number is calculated from the resulting temperature distribution. This net also affects the limiting current distribution in an SFC operating at limiting current because it disrupts the parabolic laminar flow velocity distribution. Hence, the current density distribution is obtained from the Nusselt number distribution through a heat and mass transfer analogy. The location, spacing, and number of the longitudinal and transverse ribs of the net are shown to affect the local and average current density distributions and Nusselt numbers on each of the two electrode plates. The results show that transverse ribs have a greater effect and that the enhancements of the average current density of 250% can be obtained for a spacing of 0.94 x 10-3 m with greater than 16 transverse ribs.; A silver-zinc battery shows similar mass transfer limitations while discharged at moderate to high discharge rates. A one-dimensional mathematical model consisting of a negative (zinc) electrode, separator, and positive (silver) electrode, has been developed to study the performance and thermal behavior of the silver-zinc cell during discharge. The physical phenomena described here are reaction kinetics, mass transfer and heat generation. The analysis includes finite matrix conductivities (thermal and electrical), variable physical properties and takes into account the simultaneous reactions in the positive electrode. Movement of the reaction front observed in the negative electrode and changes in porosity, electrolyte composition due to electrochemical reactions, local reaction rates, diffusion and migration of electrolyte have been reported. A study of influence of various parameters on the cell voltage-time curves has been presented. The effects of initial electrolyte composition, exchange current densities, tortuosity and discharge rates are presented and the factors that may limit cell performance have been identified. The temperature rise in a single cell was predicted and observed to agree with the experimental values.