Investigation of the factors influencing skid resistance and the international friction index

This dissertation is compiled of the findings of several phases of a detailed research study that was aimed at investigating the Skid Resistance phenomenon.;In the first phase of the dissertation research a study was performed to evaluate the different factors that influence frictional measurements obtained using the Dynamic Friction Tester (DFT). A temperature calibration factor that would account for temperature effects on DFT readings and IFI computations was developed. In addition, other variables that also affect the friction measurements obtained using the DFT are identified.;In the next phase of the dissertation research the effect of pavement roughness on the Skid Resistance was investigated. The variation of the normal load and its nonlinear relation to SN was used to explain lower SN values measured on relatively rougher surfaces. The feasibility of using the International Roughness Index (IRI) and the Dynamic Load Coefficient (DLC) as predictors of the reduction in SN due to pavement roughness was also investigated.;In the final phase of the dissertation research an in-depth investigation was carried out to better understand the principles underlying the concept of the International Friction Index (IFI), and specifically the role played by the Speed Constant (Sp) parameter in the IFI computations. The parameter Sp dictates the speed variation of the wet friction measurements taken on a given pavement surface. The results of the current investigation suggest the revision of the procedure for computation of the Sp parameter to incorporate device specific properties.;Furthermore, the incorporation of vehicle characteristics in the Sp parameter computations would help address a well known deficiency of the IFI, which is the inconsistent FR60 (predicted friction at 60 km/h) obtained from the friction values measured at two different slip speeds on the same surface. This study also showed that the modification of the Sp parameter reduces significantly the slip speed dependency of the device calibration parameters A and B.;Finally, a modified IFI procedure that incorporates device specific slip conditions is presented. The modified IFI procedure showed consistently better predictive capability than the conventional ASTM procedure on all the different devices considered in this study.