| It is known that benzene, toluene, ethylbenzene and xylene isomers, volatile organic compounds (VOCs) commonly called BTEX, have toxic health effects on humans and plants depending on duration and levels of exposure. Benzene in particular is classified carcinogenic, and exposure to benzene at concentrations above 64 g/m3 can be fatal within 5--10 minutes. Therefore, real-time monitoring of BTEX in ambient air is essential for the early warning detection associated with their release and in estimating the potential exposure risks to living beings and the environment. In this thesis, a real-time analysis method for BTEX in ambient air was developed and validated. The method is based on the direct-air sampling technique coupled with tandem mass spectrometry using atmospheric pressure chemical ionization (direct APCI-MS/MS). Validation of the method has shown that it is sensitive (limit of detection LOD 1.2 mug/m3), precise (relative standard deviation RSD < 10%), accurate (accuracy > 95%) and selective. Ambient air samples from an industrial waste landfill site and various automobile repair shops were analyzed by the developed method. Comparison of results with those obtained by online gas chromatography coupled with a flame ionization detector (GC-FID) technique exhibited similar results. The capacity of the method for the fast evaluation of potential risks associated with an exposure to BTEX has been demonstrated through a field study with health risk assessment for workers at three automobile repair shops and through experiments under simulated atmospheres. Concentrations measured in the ambient air of the garages were in the ranges of 8.9--25 mug/m3 for benzene, 119--1156 mug/m 3 for toluene, 9--70 mug/m3 for ethylbenzene, and 45--347 mug/m3 for xylenes. A total environmental daily dose of 1.46x10-3.2.52x10-3 mg/kg/day was determined for benzene. The estimated cancer risk due to the total environmental exposure to benzene was between 1.1x10-5 and 1.8x10-5 for the workers studied.Keywords. Volatile organic compound, BTEX, benzene, octamethylcyclotetrasiloxane D4, decamethylcyclopentasiloxane D5, siloxane, ambient air, landfill biogas, direct sampling-mass spectrometry, APCI-MS/MS.A novel APCI-MS/MS method was also developed and validated for the direct analysis of octamethylcyclotetrasiloxane (D4) and decamethylcyclopentasiloxane (D5) in air and biogases. D4 and D5 are cyclic volatile siloxanes widely used in industrial processes and consumer products as replacement solvents for the tropospheric ozone forming VOCs, such as BTEX. Their ubiquitous presence in ambient air samples, due to the growing consumption, raises the need for toxicity studies which require qualitative and quantitative trace analysis of these compounds. Furthermore, the presence of trace amounts of these substances in a biogas hampers its use as a source of renewable energy by causing expensive damages to the equipment. Thus, siloxane analysis of the biogas is essential in determining if purification is needed before the use for energy production. The method developed in this study for these aims has good sensitivity (LOD 4--6 mug/m3), good precision (RSD < 10%), good accuracy (> 93%) and high selectivity. It was also shown that by using this method with hexamethyl-d18-disiloxane as an internal standard, detection and quantification of D4 and D5 in real biogas samples can be done with a better sensitivity (LOD &sim 2 mug/m3), high precision (RSD < 5%), and high accuracy (> 97%). Various biogas samples collected from the landfill site of the Complexe Environnemental de Saint-Michel in Montreal have been successfully analyzed by this new method. Concentrations measured were in the ranges of 131--1275 mug/m 3 for D4 and 250--6226 mug/m3 for D5. These results represent the first primary-literature-reported data on siloxanes D4 and D5 contents of landfill-derived biogases as a function of the refuse age. |
