Research Of Waste Heat Recovery From Aluminum Industry

Around half of the energy consumed in aluminum production is lost as waste heat.Approximately 30-45% of the total waste heat is carried away by the exhaust gas from the smelter and is the most easily accessible waste heat stream.Alcoa Fjardaal in east Iceland produces 350 000 tons annually,emitting the 110 °C exhaust gas with 88.1 MW of heat.This work concentrates on creating models of low-temperature energy utilization from the aluminum production.Three scenarios,including organic Rankine cycle(ORC)system,heat supply system and combined heat and power(CHP)system,were proposed to recover waste heat from the exhaust gas.The electric power generation potential is estimated by ORC models.The maximum power output was found to be is 2.57 MW for an evaporation temperature of 61.22°C and R-123 as working fluid.42.34 MW can be produced by the heat supply system with the same temperature drop of the exhaust gas in the ORC system.The heat requirement for local district heating can be fulfilled by the heat supply system,and there is a potential opportunity for agriculture,snow melting and other industrial applications.The CHP system is more comprehensive.1.156 MW power and 23.55 MW heating capacity can be produced by CHP system.The highest energy efficiency is achieved by the heat supply system and the maximum power output can be obtained with the ORC system.In the power generation system,the efficiency of organic Rankine cycle is significantly limited by the low temperature of the exhaust gas.An effective measure to improve the efficiency of the ORC is the increment of heat source temperature.The temperature of the heat source is uplifted by reducing the dilution air from the environment into the pot.The heat balance of the smelter is studied.The positive result is found,that the efficiency of the cycle and power output are effectively improved,and a good trend of the systemic performance can be observed.The maximum 9.174 MW power can be produced at the gas exhaust gas temperature of 150 °C,and the systemic exergy efficiency of 54.38% can be achieved in this condition.The heat balance is an issue in this promotion.The heat loss to ambient reduces with less dilution air.The arrangement of the thermal resistance of the smelter has to be redesigned in order to keep the heat balance and avoid the heat accumulation.A good potential for heat and power production is found by recovering the waste heat from aluminum production in this work.The efficiency of energy utilization in aluminum production can be effectively improved as studied.