The Paper Cups Molding Machine Package Leaves Transmission’s Optimization Design And Simulation

In people pursuit is convenient, health, safety and environmental protection of modernsociety, disposable cups in People’s Daily life gradually reflect its advantage. And along withthe disposable plastic cup exit modern consumer market step by step, disposable paper cup isbecoming the mainstream of the modern social disposable cup; In addition, because automaticpaper cups molding machine reasonable structure, small power consumption, high efficiency,stable performance, easy to operate, can further meet the increasing market demand.Therefore, paper cups of the machines wide prospect of market, while for the paper cups ofthe machines research is very practical.As the market growing demand for paper cups, therefore, ask to be automatic paper cupsmolding machine research, design and improve work also should keep pace with The Times.According to the domestic and foreign commonly used to be automatic paper cups moldingmachine, it is known that the paper cups molding machine basically has the following processthat is the paper cutting, automatic paper feeding, cup body roll, and rushed at the bottom andnote oil, sealing, preheating, heating, turn over the bottom, knurling, edge, cup, a cup andback. This design main finish the paper cups molding machine body coiling part of the cup oftransmission system design or packets leaves of transmission system design, this part of themain body of the cup including paper cups rolling process, this is the whole machine designof important relative a research link, directly related to the qualified rate of the machines andpaper cups production efficiency. According to the paper cups machine a body to make thatcup process, packet transmission mechanism are the main lobe of the CAM andCAM-composed of connecting rod link mechanism, and the CAM contour curve control theconnecting rod the work trajectory. Therefore, this design according to the CAM-linkagemechanism of the work requirements and track bag leaves transmission’s sports load conditionselected the movement equation curve CAM work, using the plural vector operationmechanism of connecting rod movement analysis, in the movement on the basis of analysis,the dynamic analysis is based on the principle of lang bell, calculated by the connecting rod offorce and LiOu, then use of ANSYS software of high-speed CAM-the linkage mechanism toreality of the worst mode of the finite element analysis, and on this basis to optimize thelinkage analysis, the optimization design of link with the actual conditions of the worst of therequirements, and then, with the connecting rod optimization design based on a CAM-linkagemechanism of the elastic dynamics model, and use the elasticity of the CAM-linkagemechanism dynamic model as the foundation, according to the CAM linkage mechanism motion differential equations of the work is deduced the CAM contour curve, and by usingPRO/E solid modeling software module to the CAM for accurate modelling design, finallyusing PRO/E motion simulation software module to the bag leaves transmission mechanismmotion simulation, test design is to achieve the desired motion demand. The verification,packet transmission mechanism, the connecting rod work with the expected trajectory track,the design of this topic research will effectively improve the paper cups molding machinebody coiling this location cup the qualified rate and productivity.