Bioconversion of cellulose into electrical energy in microbial fuel cells

In microbial fuel cells (MFCs), bacteria generate electricity by mediating the oxidation of organic compounds and transferring the resulting electrons to an anode electrode. The first objective of this study was to test the possibility of generating electricity with rumen microorganisms as biocatalysts and cellulose as the electron donor in two-compartment MFCs. Maximum power density reached 55 mW/m2 (1.5 mA, 313 mV) with cellulose as the electron donor. Cellulose hydrolysis and electrode reduction were shown to support the production of current. The electrical current was sustained for over two months with periodic cellulose addition. Clarified rumen fluid and a soluble carbohydrate mixture, serving as the electron donors, could also sustain power output. The second objective was to analyze the composition of the bacterial communities enriched in the cellulose-fed MFCs. Denaturing gradient gel electrophoresis of PCR amplified 16S rRNA genes revealed that the microbial communities differed when different substrates were used in the MFCs. The anode-attached and the suspended consortia were shown to be different within the same MFC. Cloning and analysis of 16S rRNA gene sequences indicated that the most predominant bacteria in the anode-attached consortia were related to Clostridium spp., while Comamonas spp. was abundant in the suspended consortia.;The external resistance affects the characteristic outputs of MFCs by controlling the flow of electrons from the anode to the cathode. The third objective of this study was to determine the effect of various external resistances on power output and coulombic efficiency of cellulose-fed MFCs. Four external resistances (20, 249, 480, and 1000 ohms) were tested with a systematic approach of operating parallel MFCs independently at constant circuit loads for three months. A maximum power density of 66 mWm-2 was achieved by MFCs with 20 ohms circuit load, while MFCs with 249, 480 and1000 ohms external resistances produced 57.5, 53 and 47 mWm-2, respectively. The anode potential varied under the different circuit loads employed. Higher coulombic efficiencies were achieved in MFCs with lower external resistance.;The effect of different external resistances on the bacterial diversity and metabolism in cellulose-fed MFCs was investigated as the fourth objective. DGGE analysis of partial 16S rRNA genes showed clear differences between the planktonic and the anode-attached populations at various external resistances. Cellulose degradation was complete (< 0.1% residual), and there were no discernible differences among the MFCs. HPLC analysis of short chain fatty acids (SCFA) revealed that anaerobic degradation of cellulose was accompanied by production of acetic, propionic, butyric, isobutyric, valeric, isovaleric, and lactic acids, with acetic acid being predominant. The profile of metabolites was different among the MFCs. The concentrations of SCFA were higher in MFCs with larger external resistance. High levels of SCFA indicated that fermentative metabolism dominated over anaerobic respiration, resulting in relatively low coulombic efficiencies. The accumulation of SCFA at higher circuit resistances corresponded to lower power outputs.;Methanogenesis shifts the flow of electrons available from the substrate away from electricity generation in MFCs. The fifth objective of this research was to assess the influence of methane formation on the performance of cellulose-fed MFCs under long-term operation. A maximum volumetric power density of 3.5 W m-3 was achieved in R20O MFCs, which was three times greater than that obtained with R100O MFCs (1.03 W m-3).;The diversity of methanogens in cellulose-fed MFCs was also characterized. It was shown that the suppression of methanogenesis was accompanied by a decrease in the diversity of methanogens and changes in the concentration of SCFA, as revealed by DGGE analysis of PCR-amplified 16S rRNA genes and HPLC analysis, respectively. Analysis of partial 16S rRNA gene Sequences indicated that the most predominant methanogens were related to the family Methanobacteriaceae .;The results demonstrate that electricity can be generated from cellulose by exploiting rumen microorganisms as biocatalysts. Results suggest that oxidation of metabolites with the anode as an electron sink was a rate limiting step in the conversion of cellulose to electricity in MFCs. This study also demonstrates that the size of external resistance significantly affects the bacterial diversity and characteristic output of MFCs. Thus the external resistance may be a useful tool to control microbial communities and consequently enhance performance of MFCs. Furthermore, this study shows that methanogenesis competes with electricity generation at the early stages of MFC operation but operating conditions suppress methanogenic activity over time. An improved understanding of the microbial communities, interspecies interactions and processes involved in electricity generation is essential to effectively design and control cellulose-fed MFCs for enhanced performance. In addition, technical and biological optimization is needed to maximize power output of these systems.