Development and applications of inkjet printed conducting polymer micro-rings

A drying sessile drop moves the solute particles to the periphery where they get deposited in the form of a ring. This phenomenon is prevalent even with micro drops falling at high velocity from a piezo-actuator based inkjet printer. In polymer microelectronic field, this phenomenon is a major challenge for fabricating devices using inkjet printing. We exploited this problem and applied it for various novel applications in the field of polymer microelectronics.; Various dispensing techniques and temperature variations for micro-drop printing were used for modifying the micro-drops in such a way that the periphery of the micro-ring holds most of the solute as compared to inner base layer. Reactive ion etching (RIE) was used for removing the inner base layer in order to make the micro-rings completely hollow from the center. These micro-rings were applied in the fabrication of polymer light emitting diode, humidity sensor and vertical channel field effect transistor.; High resolution polymer light emitting diode array (>200 pixels/inch) was fabricated by inkjet printing of micro-ring and each micro-ring acts as a single pixel. These micro-rings were applied as a platform for layer-by-layer (LbL) nano-assembly of poly-3,4-ethylenedioxythiophene:poly-styrenesulfonate (PEDOT:PSS) for the fabrication of humidity sensor. Enhanced sensitivity of the humidity sensor was obtained when the inkjet printed micro-rings are combined with LbL assembled PEDOT:PSS films. During the fabrication of vertical channel field effect transistors, inkjet printed PEDOT:PSS micro-rings were used as source and the inner spacers between the adjacent micro-rings were used to make channel.; These micro-rings can also find other applications in the field of biological sciences. These micro-rings can be used as cell culture plates and as scaffolds for cell and/or tissue growth.