Procedures - Globe Thesis

Keyword [Procedures] Result: 161 - 180 \| Page: 9 of 10
161.	Development of guidelines for erection procedures for horizontally curved steel I-girder bridges through analysis of a parametric group of bridges
162.	Assessing continuous descent arrivals and instrument procedures towards increased runway landing capacity
163.	Real-time seismic hybrid simulation procedures for reliable structural performance testing
164.	Improvements in design procedures for ground source and hybrid ground source heat pump systems
165.	Novel cathodes for solid oxide fuel cells prepared by impregnation procedures
166.	Development and evaluation of test procedures to identify moisture damage prone hot mix asphalt pavements
167.	Accuracy and stability of transient multiphysics simulations
168.	Durability of green concrete as a structural material
169.	Development of acoustic emissions testing procedures applicable to conventionally reinforced concrete deck girder bridges subjected to diagonal tension cracking
170.	Evaluation of the service II limit state for AASHTO elastic and moment redistribution procedures
171.	Design of an experimental facility for the validation of cooling load calculation procedures
172.	Effectiveness of the stress relief procedures and their effects on local buckling behaviour of buried pipes
173.	Three dimensional behavior of retaining wall systems
174.	Investigation of the vertical distribution of seismic forces in the static force and equivalent lateral force procedures for seismic design of multistory buildings
175.	Analytical Study of Gusset Plate Joints in Steel Truss Bridges and Development of Assessment Procedures
176.	On goodness -of -fit tests of semiparametric models
177.	Experimental laboratory procedures for the construction and testing of seismic resistant unbonded post-tensioned special reinforced concrete walls
178.	Validation of Superpave mixture design and analysis procedures using the NCAT test track
179.	Reducing uncertainties in estimation of wind effects on tall buildings using aerodynamic wind tunnel tests
180.	Development of Procedures for Accurate Finite Element Modeling of the Dynamic and Quasi-Static Performance of Automotive Chassis Components Incorporating Hyperelastic Materials
<<First <Prev Next> Last>> Jump to