Modeling Test - Globe Thesis

Keyword [Modeling Test] Result: 21 - 40 \| Page: 2 of 3
21.	Highway Tunnel Reasonable Lining Section Type Test
22.	The Loess Subgrade Compaction Characteristics
23.	Geocell, Engineering Properties Of The Flexible Retaining Wall Centrifuge Model Test Research
24.	Bridge Pile Bearing Characteristics Of The Centrifuge Model Test
25.	Mechanical Performance Analysis Of Steel Frame With Tenon-and-Mortise Joints
26.	The Hydroelasticity Analysis Of Ship Wave Loads And Its Effect On Fatigue Strength
27.	Numerical Application And Centrifugal Modeling Study Of A Non-coaxial Constitutive Model
28.	Research On Key Issues Of Tire Modeling Using Modal Parameters
29.	The Study On The Foundation Settlement Of Deep Soft Clay With Centrifugal Modeling Test
30.	Centrifuge Modeling Test And FEM Analysis Of Reinforced Slope
31.	Research On The Horizontal Bearing Characteristics Of Pile Socketed In Sofe Rock At Plateau Reservoir Area
32.	The Study Of Centrifugal Modeling Test On Bearing Capacity Of Single Pile Under Horizontal Load
33.	The Mechanism And Characteristics Study On Rebound And Recompression Of Immersed Tube Tunnel Foundation Off The Coast
34.	The Modeling Study And Simulation Of The Large Gas Turbine’s Test System
35.	Research Of The Technology Of Prestrained Reinforcement And Dynamic Compaction On High-filled Embankment
36.	Centrifugal Modeling Test Study On Force And Deformation Characteristics Of Corrugated Steel Pipe Culverts
37.	Mechanical Characteristics Research Of Pipe Culverts Under High Embankments In Southern Mountain Areas By Centrifuge Modelling Tests
38.	An Experimental Study Of The Characteristics Of Tunnel Water Burst In Fault Fracture Zone
39.	Research On Test System Of Communication Network For Smart Distribution And Consumption Network
40.	Design And Modeling Test Of New Flat Die Pelleting Mill With Plunger
<<First <Prev Next> Last>> Jump to