Font Size: a A A
Keyword [High temperature tensile]
Result: 41 - 60 | Page: 3 of 5
41. Research On Microstructure Properties And Creep Behaviors Of A MA21 Alloy
42. Effects Of Y And Gd On Microstructure And Properties Of AZ91D Magnesium Alloy
43. Study On The Superplasticity Of Powder Metallurgy Equiaxed Duplex ?-TiAl-based Alloy
44. Study On Mechanical Properties Of TiAl-based Alloy At High Temperature
45. Hot Deformation Characteristics Of Particles Reinforced 8009 Aluminum Matrix Composites
46. Biaxial Failure Mechanism And High Temperature Tensile Properties Of Needled C/C-SiC Composite
47. Research On High Temperature Mechanical Behavior Of Mg-Gd-Y Alloys
48. Effect Of Zr,Hf Addition On The Microstructure And Tensile Properties Of FeCrAl-ODS Steels
49. Effects Of Temperature And Strain Rate On High Temperature Mechanical Properties Of Al Based Amorphous Alloys
50. Microstructure Evolution And High Temperature Tensile Properties Of Controlled Rolling Mg–Al–Zn Alloys
51. The Strengthening Behavior Of The 1Cr9Al1-3Ni1-7WVNbB High Al Ferritic Heat-resistant Steel
52. Research On The Heated Microstructure Optimization And High-temperature Properties Of New Single Crystal Nickel-based Superalloy With Low Rhenium
53. Investigation On Microstructure And Properties At High Temperature And Hot Rolling Technology Of 2205 Duplex Stainless Steel
54. Research On Deformation Behavior Of Zr50Cu40Al10and Fe78Si9B13Amorphous Alloys At High Temperature
55. Effect Of Rare Elements On Microstructure And Properties Of Heat-resistant Steels
56. The Effect Of Ti/TC4 On High Temperature Tensile Properties And Deformation Mechanism Of The ?-TiAl Based Alloy
57. Study On Fatigue Characteristics And Fracture Behavior Of High Strength And High Toughness AlMgSiCu Alloy Sheet
58. Heat Treatment Optimization And High Temperature Performance Of Nickel-base Single Crystal Superalloy DD5
59. Effect Of Alloying Elements And Heat-treatment On The High Temperature Strength Of Eutectic Al-Si Alloys
60. Study On High-temperature Tensile Properties And Forming Limit Of 7075 Aluminum Alloy Sheet Based On Hot Stamping
  <<First  <Prev  Next>  Last>>  Jump to