| High performance, micro-g resolution, small size, low cost, low power accelerometers are needed in many applications such as inertial navigation, Unmanned Aerial Vehicles (UAVs), and GPS augmentation. Many low-medium performance accelerometers have been commercialized for automotive applications. Several sensing methods have been used, including piezoresistive, piezoelectric, resonant beam, tunneling, and capacitive techniques. Capacitive sensing has several advantages in terms of high sensitivity, stable DC-characteristics, low power dissipation, low temperature sensitivity, and low noise floor.; This research work demonstrates full functionality of high-sensitivity, low-noise capacitive multi-axis accelerometers. In order to achieve micro-g resolution, two different structures have been utilized: a Silicon-On-Glass (SOG) accelerometer, and an all-silicon accelerometer. A monolithic fabrication technique for Post-CMOS MEMS is also developed. Finally, a 3-axis single-chip accelerometer is presented.; The SOG configuration is implemented with a high aspect-ratio structure (120μm-thick single crystal silicon and bonded to a glass substrate), formed using Deep RIE. It has a 3.4μm sensing gap and a simple 3-mask, 5-step process. A hybrid microsystem consisting of the SOG accelerometer and Σ-Δ switched-capacitor readout circuit provides 0.15pF/g sensitivity and 80μg/√Hz noise floor.; A monolithic circuit-MEMS fabrication technology utilizing a dielectric bridge, silicon islands, and the SOG configuration has been developed. This technique is simple, robust, and fully Post-CMOS compatible. A glass substrate supports the silicon islands and signal routing is provided with the help of a dielectric bridge between the silicon islands.; An all-silicon in-plane accelerometer has been implemented using a combined surface and bulk micromachining technology. By taking advantage of the technology, a full-wafer thick proof-mass, large sensing area, and small sensing gap are obtained. The accelerometer combined with the readout circuit provides 5.6pF/g sensitivity and 1.6μg/√Hz noise floor, which is the best reported performance for in-plane micromachined silicon accelerometers.; Finally, two in plane and one out-of-plane accelerometers are integrated on a single substrate. The accelerometer system is small in size, self-aligned, and easy to package. All three devices have >3pF/g sensitivity and sub-μg/√Hz mechanical noise floor. The 3-axis accelerometer with the readout circuit provides noise floor of 1.6μg/√Hz and 1.1μg/√Hz for in-plane and out-of-plane devices, respectively. |
