injection - Globe Thesis

Keyword [injection] Result: 181 - 200 \| Page: 10 of 10
181.	Design And Finite Element Analysis On The Integral Injector Of Diesel Engine
182.	Simulation Of A Pump_Nozzle Fuel Injection System For Diesel Engine
183.	Design And Research On An Electro-hydraulic Injector Of High Pressure Common Rail Fuel Injection System For Diesel Engine
184.	The Research Of Lean Burn Jet Combustion System With The Ignition Chamber
185.	Study On New GDI Engine Electronic Control System Based On ATmega16L Microcontroller
186.	The Experiment Research Of Low Temperature Premixed Combustion On Diesel Engine
187.	Research On Three-Phase Single-Switch Boost Type Harmonic Injection PFC Rectifier Based On One-Cycle-Control Technique
188.	The CAD Development For Interior Ballistic Design Of Gas-steam Launching Power System With Water Injection In Block
189.	Study And Manufacture Of The Dual Fuel System Of The Electronical Injection Engine Base On Can Bus
190.	Experimental Study On Microcosmic Pore Fractal Characteristics Of Eco-material
191.	The Measurement And Study On Fuel Consumption Of Electronic Gasoline Injection Engine
192.	Application Of Impingement Nozzle And Pilot To Diesel Premixed Charge Compression Ignition Combustion
193.	The Design And Validation Of BIT For Aero-engine Electronic Controller
194.	Study On The Sensor Of Automobile Electronically Controlled Gas-injection Control System
195.	The Electromagnetic Study Of The High Voltage Transmission Line Of The Neutral Beam Injection In The ESAT Tokamak
196.	Development Of Liquid Helium Cryocondensation Pump For Drift Tube Of Neutral Beam Injection System
197.	Sensorless Control Of Permanent Magnet Synchronous Machine Based On High Frequency Signal Injection And Kalman Filter
198.	Investigation Of High Frequency Signal Injection Based Sensorless Operation For PMSM
199.	Study On Fault Distance Measurement Methods In 10kV Automatic Blocking And Continous Transmission Lines
200.	Study On The Key Techniques Of Gas-assisted Injection Molding In Automobile Injection Molding Parts
<<First <Prev Next> Last>> Jump to